WARNING AND WARNING INDICATOR LIST <Standard meter>


Due to the addition of TPMS, the TPMS warning lamp in the combination meter warns the driver when there is a TPMS-related problem.
Item
Indicator
State

Warning operation
Warning cancellation condition (when any of the condition met)
TPMS warning lamp bulb open circuit check


The power supply mode is other than OFF ON.
Illuminates for 3 seconds.
3 seconds have passed after the TPMS warning lamp is lit.
Tyre pressure alarm


The received tyre pressure value is under the alarm ON threshold value.
Illuminates.
The received tyre pressure value is over the alarm OFF threshold value.
Low tyre inflation pressure warning threshold value reset


Low tyre inflation pressure warning threshold value reset is activated.
Flashes slowly.
When a signal from each tyre has been received and low tyre inflation pressure warning threshold value reset has been completed.
TPMS failure warning
ID not stored


The TPMS transmitter ID is not registered in the KOS-ECU or ETACS-ECU <Vehicles without KOS>.
Flashes*
ID is registered normally.
Defective EEPROM <KOS only>
Abnormality of data in the EEPROM of the KOS-ECU is detected.
Data in the EEPROM of the KOS-ECU is checked to be normal.
Problem in signal reception
The signals from TPMS transmitters cannot be received while driving for about 10 minutes.
The signal from the TPMS transmitter that was warned is received.
Defective sensor
The sensor failure signal is received from the TPMS transmitter.
A normal signal is received from the TPMS transmitter that was warned.
note *: Change to continuous illumination after flashing for about 1 minute.