|
1.
caution |
The locking nut for the piston
rod inside the shock absorber
may be loose. Do not use an impact wrench to
loosen the self-locking nut.
|
Install special tool spring compressor (MB991796) to
special tool attachment B (MB991793)
as shown in the figure.
|
|
2.Set the shock absorber
assembly to the following special tools:
- Spring compressor (MB991793)
- Attachment B (MB991796)
- Upper plate (MB991794)
- Fixture (MB991830)
note |
Use the bolts and nuts removed
from the vehicle to secure the shock absorber
assembly
and tighten them lightly by hand.
|
3.After setting the shock absorber assembly,
operate the spring compressor and compress
the coil spring by approximately 5 mm.
|
|
4.While holding the piston
rod as shown in the figure, remove the self-locking
nut.
|
|
Before disposal of the shock
absorber, place the shock absorber on the level surface with
the piston rod extended, and make a hole of approximately 3
mm in diameter at the point shown
in the figure to discharge the gas.
|
|
1.Align the end of the coil
spring with the shock absorber as shown in the
figure.
|
|
2.Set the shock absorber
assembly to the following special tools:
- Spring compressor (MB991793)
- Attachment B (MB991796)
- Upper plate (MB991794)
- Fixture (MB991830)
note |
Use the bolts and nuts removed
from the vehicle to secure the shock absorber
assembly
and tighten them lightly by hand.
|
|
|
Counter the piston rod of the shock
absorber as shown in the figure, and tighten the
self-locking
nut to the specified torque. Tightening torque:
25 ± 5 N·m
|