|
1.Remove the brake pad, shim
and clip (Refer to ).
|
|
2.Using a spring scale,
measure the hub sliding torque in the forward direction with
the
brake pad, shim and clip removed. 3.Install the
brake pad, shim and clip (Refer to ). 4.Start
the engine, and depress the brake pedal lightly two or three
times. Then stop
the engine. (Depressing force: approximately 50 - 100
N) 5.Turn the brake disc 10 times in the forward
direction. 6.Using a spring scale, measure the hub
sliding torque in the forward direction with
the brake pad, shim and clip installed. 7.Obtain
the disc brake drag force (difference between measured
values of item 2 and
item 6). Standard value:
68
N or less <Front> 68 N or less
<Rear>
8.If the brake
drag force exceeds the standard value, disassemble the brake
caliper
assembly to check for fouling/rust on the piston
sliding section and piston seal deterioration,
and confirm whether the guide pin and lock pin slide
properly (Refer to
<Front> or
<Rear>).
|