|
- ABS-ECU sends the illumination request signal of the break warning lamp to
the combination meter through ETACS-ECU via the CAN communication.
- ABS-ECU illuminates brake warning lamp via ETACS-ECU for approximately 3 seconds
for bulb check with the ignition switch turned to the ON position.
|
|
This may be caused by faults in the CAN bus line, ETACS-ECU, combination meter or ABS-ECU.
|
|
- Damaged wiring harness and connectors
- Malfunction of ETACS-ECU
- Malfunction of combination meter
- Malfunction of ABS-ECU
|
|
Use M.U.T.-III to diagnose the CAN bus lines.
|
|
Q.
Is the check result normal?
|
|
Repair the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ).
Then go to Step 7.
|
|
|
|
Use M.U.T.-III to check the diagnosis code for the ABS system.
|
|
Q.
Is the diagnosis code set?
|
|
Carry out the diagnosis for the diagnosis code (Refer to ).
|
|
|
|
Perform the following special function by the combination meter system, and check if the
ABS warning lamp illuminates (Refer to GROUP 54A - Combination Meter ).
|
|
Q.
Is the check result normal?
|
|
Replace the combination meter.
|
|
|
|
Using M.U.T.-III, check that diagnosis code No.U0141 is not set by the combination meter
system.
|
|
Q.
Is the diagnosis code set?
|
|
Diagnose the combination meter (Refer to GROUP 54A - Combination Meter/Troubleshooting ). Then
go to Step 7.
|
|
|
|
Using M.U.T.-III, check that diagnosis code No. U0121 is not set by the ETACS system.
|
|
Q.
Is the diagnosis code set?
|
|
Perform troubleshooting on ETACS-ECU (Refer to GROUP 54A - ETACS/Troubleshooting ).
Then go to Step 7.
|
|
|
|
Q.
Does the brake warning lamp turn ON and OFF normally?
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/How
to Cope with Intermittent Malfunctions ).
|
|
|
|
Replace the hydraulic unit (integrated with ABS-ECU) (Refer to ).
Then go to Step 7.
|
|
|
|
Q.
Does the brake warning lamp turn ON and OFF normally?
|
|
This diagnosis is complete.
|
|
|