|
In case of this trouble symptom, the stability control/TCL system operation may
be disabled. Diagnosis code may be set by the stability control/TCL system using M.U.T.-III.
|
|
- Low battery output
- Wiring harness or connector failure of CAN bus line
- ASC-ECU malfunction
- Engine coding data problem
|
|
Use M.U.T.-III to check the diagnosis code for the ASC system (Refer to ).
|
|
Q.
Is the check result normal?
|
|
Carry out the diagnosis for the diagnosis code (Refer to ).
|
|
|
|
Using M.U.T.-III, check if any abnormality is present to the coding data below which are
stored in the engine-ECU (Refer to GROUP 00 - Precautions before Service/Coding
List ).
|
|
Q.
Is the check result normal?
|
|
Perform the variant coding to the Engine ECU.
|
|
Q.
Is the check result normal?
|
|
Replace the engine ECU (Refer to GROUP 13A - Engine-ECU <4B1>,
GROUP 13B - Engine-ECU <6B3>). Then go to Step
5.
|
|
|
|
Check that the brake tube is correctly mounted to the hydraulic unit (integrated with
ASC-ECU) (Refer to ).
|
|
Q.
Is the check result normal?
|
|
Replace the hydraulic unit (integrated with ASC-ECU) (Refer to ). Then
go to Step 5.
|
|
|
|
Connect the brake tubes correctly, and repair or replace the external brake lines
of the hydraulic unit (integrated with ASC-ECU).
|
|
|
|
Q.
Does stability control/TCL operate normally?
|
|
This diagnosis is complete.
|
|
|
|
Check the brake system related components other than the stability control/TCL
system.
|
|
|