Code No. C2298
Ambient sensor signal
caution |
- Whenever the ECU is replaced, ensure
that the CAN bus lines are normal.
|
OPERATION
FCM/LDW/AHB-ECU communicates with the ETACS-ECU via the CAN bus lines.
DIAGNOSIS CODE SET CONDITION
This diagnosis code is set when the abnormality below is detected:
- The ECU receives an invalid ambient temperature signal from the ETACS-ECU.
PROBABLE CAUSES
- Defective ETACS circuit system (ambient temperature sensor)
- Malfunction of the FCM/LDW/AHB-ECU
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III other system diagnosis code.
Check the ETACS diagnosis code (Refer to 54A - Troubleshooting ).
Q.
Is the diagnosis code set?
Perform the relevant troubleshooting (Refer to 54A - Diagnosis code chart ).
Go to Step 2
STEP 2. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the FCM/LDW/AHB-ECU.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
|
|
(3)Check if diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the FCM/LDW/AHB-ECU (Refer to ).
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How
to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction).