Inspection Procedure
2: Electric power steering system warning display illuminates but diagnosis code is not stored.
|
COMMENTS ON TROUBLE SYMPTOM
|
|
The CAN bus lines may be defective. If the electric power steering system does not operate,
the combination meter or the EPS-ECU may be defective.
|
|
- Malfunction of CAN bus line
- Defective harness wire(s) or connector(s)
- Short or open circuit between the EPS-ECU and the ETACS-ECU, the fusible
link or loose connector contact
- Open circuit between the body earth and the EPS-ECU or loose connector contact
- Malfunction of the ETACS-ECU
- Malfunction of the combination meter
- Malfunction of the EPS-ECU
|
|
STEP 1. M.U.T.-III CAN bus diagnostics
|
|
Use M.U.T.-III to diagnose the CAN bus lines.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Repair the CAN bus lines (Refer to GROUP 54C -
CAN Bus Diagnostics Table ).
|
|
|
|
STEP 2. Check by M.U.T.-III "Special Function"
|
|
Using M.U.T.-III, select "Test" from the special function of the combination meter. Execute
the following item to check the liquid crystal display. (Refer to GROUP 54A -
Combination Meter )
|
|
Q.
Is the check result normal?
|
|
Go to Step 3.
|
|
|
|
Replace the combination meter.
|
|
|
|
STEP 3. Voltage measurement at the EPS-ECU connector (IG1, +BB,
GND terminal)
|
|
(1) Measure the EPS-ECU voltage without disconnecting the connector (by backprobing).
|
|
(2)Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
|
|
(3)Measure the voltage between the EPS-ECU connector (IG1 terminal) and the EPS-ECU
connector (GND terminal) or body earth. OK: Approximately system voltage
|
|
(4)Measure the voltage between the EPS-ECU connector (+BB terminal) and the
EPS-ECU connector (GND terminal) or body earth. OK: Approximately system voltage
|
|
Q.
Is the check result normal?
|
|
Go to Step 6.
|
|
|
|
Go to Step 4.
|
|
|
|
STEP 4. Check of short to power supply, short to earth, and open circuit
in +BB line between fusible link and EPS-ECU connector
|
|
Q.
Is the check result normal?
|
|
Go to Step 5.
|
|
|
|
Repair the fusible link, connector(s) or wiring harness.
|
|
|
|
STEP 5. Check of short to power supply, short to earth, and open circuit
in IG1 line between EPS-ECU connector and ETACS-ECU connector
|
|
Q.
Is the check result normal?
|
|
Go to Step 6.
|
|
|
|
Repair the connector(s) or wiring harness.
|
|
|
|
STEP 6. Retest the system
|
|
Q.
Is the check result normal?
|
|
Intermittent malfunction (Refer to GROUP 00 -
How to Cope with Intermittent
Malfunction ).
|
|
|
|
Replace the EPS-ECU (Refer to ).
|
|
|