Code No. U0141:
ETACS-ECU CAN Time-out
caution |
- If the diagnosis
code No. U0141 is set, be sure to diagnose the CAN bus line.
- When replacing the ECU, always check that the communication circuit is normal.
- When the ETACS-ECU of vehicles without KOS is replaced, the encrypted code of the ignition
key needs to be registered to the ETACS-ECU. (If the encrypted code is not registered, the engine
cannot be started. Register the encrypted code as described in Immobilizer System -
How
to Register Key ID
.)
|
DIAGNOSTIC FUNCTION
If the signal from ETACS-ECU cannot be received, the electric tailgate control unit sets
diagnosis code No. U0141.
JUDGMENT CRITERIA
With the statuses that the ignition switch is at ON position, system voltage is 10 to
16 V (data from ETACS-ECU), and there is no malfunction to the power supply fuse, or odometer
value is 80.5 km or more, if the communication with ETACS-ECU cannot be established for 2,500
ms or more, the electric tailgate control unit determines that a problem has occurred.
PROBABLE CAUSES
- Malfunction of ETACS-ECU
- Malfunction of the electric tailgate control unit
- Malfunction of CAN bus line
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnostics
Use M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 2.
Repair the CAN bus lines. (Refer to GROUP 54C -
Troubleshooting
.)
STEP 2. M.U.T.-III diagnosis code for other systems
Check if the ETACS-ECU-related diagnosis code is set.
Q.
Is the diagnosis code set?
Troubleshoot the ETACS-ECU. (Refer to GROUP 54A -
ETACS-ECU -
Troubleshooting
.)
Go to Step 3.
STEP 3. M.U.T.-III other system diagnosis code
Check if the diagnosis code No. U0141 is set to the KOS-ECU, OSS-ECU, combination meter,
SRS-ECU, MMCS, radio and CD player or A/C-ECU.
Q.
Is the diagnosis code set?
Go to Step 4.
Go to Step 5.
STEP 4. Check whether the diagnosis code is reset.
Check again if the electric tailgate control unit sets a diagnosis code.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
|
|
(3)Check if diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the ETACS-ECU.
An intermittent malfunction may be present. (Refer to GROUP 00 -
How
to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction
.)
STEP 5. Check whether the diagnosis code is reset.
Check again if the electric tailgate control unit sets a diagnosis code.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from the LOCK (OFF) position to the ON position.
|
|
(3)Check if the diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the electric tailgate control unit.
An intermittent malfunction may be present. (Refer to GROUP 00 -
How
to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction
.)