INSPECTION PROCEDURE
C-6: Power window anti-trap function does not work normally <Driver’s side
door>.
COMMENTS ON TROUBLE SYMPTOM
Malfunction of the power window motor revolution detection sensor or incorrectness of
glass slider installation is suspected.
PROBABLE CAUSES
- Malfunction of the power window motor
- Incorrectly installed or warped glass slider
DIAGNOSTIC PROCEDURE
STEP 1. Check the power window fully closed position
|
(1)Carry out the learning procedures of the power window fully closed position. Refer
to .
|
|
(2)Fully open the door window glass. Operate the power window switch to fully close
the door window glass, and check if the door window glass raise without lowering automatically.
|
Q.
Is the check result normal?
Go to Step 2
Refer to adjustment of faulty power window .
STEP 2. Check of short to power supply, short to earth, and open circuit
in SEN1, SEN2, VCC, SGND line between power window main switch connector and front power window
motor (LH <LH drive vehicles>, RH <RH drive vehicles>).
Q.
Is the diagnosis code set?
Go to Step 3
Repair the connector(s) or wiring harness.
STEP 3. Retest the system.
|
(1)Make the power widows learn their fully closed position.()
|
|
(2)Check that the power window anti-trap function works.
|
Q.
Is the check result normal?
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection
Service Points - How to Cope with Intermittent Malfunction ).
Replace the power window motor (LH <LH drive vehicles>, RH <RH drive vehicles>).