DISASSEMBLY AND REASSEMBLY


caution
  • When you remove/install or replace the camera, you should check the camera image on the multi around monitor "Bird-eye view." If necessary, calibrate the monitor (Refer to GROUP 54A - On-vehicle service, How to calibrate Multi Around Monitor ). <Vehicles with multi around monitor>
  • To ensure the camera image is clearly visible, wipe the lens with a damped rag and then a dry rag to remove dust, rain drops or snow.
  • Be careful not to damage the camera. Any damage may have an adverse effect on the screen image.
Pre-removal OperationHeadlamp Washer Removal
 Post-installation Operation
  • Headlamp Washer Installation
  • Front Fog Lamp Aiming Adjustment (Refer to GROUP 54A, Fog Lamp - On-vehicle Service).




Disassembly steps


1.
 Front bumper lamp wiring harness


2.
 Harness clamp
<<A>>
 >>A<<
 3.
 Rivet


4.
 Front bumper reinforcement


5.
 Front fog lamp bezel


6.
 Front fog lamp cover <Vehicles without front fog lamp> or Front fog lamp assembly <Vehicles with front fog lamp> (Refer to GROUP 54A, Fog lamp)


7.
 Front bumper side lower garnish


8.
 Front bumper side centre garnish
<<A>>
 >>A<<
 9.
 Rivet


10.
 Front bumper side upper garnish


11.
 Front bumper extension


12.
 Front bumper centre cover


13.
 Forward distance warning sensor <Vehicles with ultrasonic misacceleration mitigation system>


14.
 Forward distance warning sensor bezel <Vehicles with ultrasonic misacceleration mitigation system>


15.
 Front bumper cover <Vehicles with ultrasonic misacceleration mitigation system>


16.
 Front corner clearance sensor <Vehicles with ultrasonic misacceleration mitigation system>


17.
 Front corner clearance sensor bezel <Vehicles with ultrasonic misacceleration mitigation system>


18.
 Front-view camera hole cover <without front-view camera>


19.
 Front-view camera


20.
 Front bumper face

DISASSEMBLY SERVICE POINT

<<A>> RIVETS REMOVAL

Use a drill (Φ 4.0 mm) to make a hole in the rivet to break it, and remove the rivet.

REASSEMBLY SERVICE POINT

>>A<< RIVETS INSTALLATION

Use a rivet tool shown as in the illustration to connect the parts with rivets by the following procedures:
1.Insert the rivet into a corresponding location.
2.Set the rivet tool at a portion A of rivet.
3.While pushing the flange surface of the rivet onto parts to be fixed with the rivet tool, press the handle of the tool.
4.Thin part of portion A of the rivet will be cut off and the part is fixed in position.