REMOVAL AND INSTALLATION

caution

When you remove/install or replace the camera, you should check the camera image on the multi around monitor "Bird-eye view." If necessary, calibrate the monitor (Refer to GROUP 54A - On-vehicle service, How to calibrate Multi Around Monitor ). <Vehicles with multi around monitor>
To ensure the camera image is clearly visible, wipe the lens with a damped rag and then a dry rag to remove dust, rain drops or snow.
Be careful not to damage the camera. Any damage may have an adverse effect on the screen image.

Pre-removal and Post-installation Operation

Front Door Sash Trim Removal and Installation (Refer to GROUP 52A, Door Trim).
Front Door Trim Removal and Installation (Refer to GROUP 52A, Door Trim).
Door Mirror Assembly Connector Connection

			Removal steps
		1.	Door mirror assembly
<<A>>		2.	Mirror
		3.	Rear view mirror cushion
		4.	Door mirror outer cover
		5.	Connection of side turn-signal lamp connector
		6.	Door mirror base cover
		7.	Screw
		8.	Side turn-signal lamp assembly
		9.	Screw
		10.	Rear view mirror cover <Vehicle with multi around monitor>
		11.	Rear view mirror spacer <Vehicle with multi around monitor>
		12.	Connection of camera wiring harness connector <Vehicle with multi around monitor>
		13.	Side-view camera <Vehicle with multi around monitor>
		14.	Screw
		15.	Camera support <Vehicle with multi around monitor>
		16.	Screw
		17.	Actuator
<<B>>	>>A<<	18.	Door mirror main wiring harness connector
		19.	Door mirror base
		20.	Rear view mirror retractor motor
		21.	Door mirror housing
			Remote controlled mirror switch removal steps
		·	Remote controlled mirror switch (Refer to GROUP 52A, Door Trim.)

REMOVAL SERVICE POINT

<<A>> MIRROR REMOVAL

caution

The tab of the mirror is prone to breakage when working in cold temperatures. Always use a hair drier or the like to warm up the mirror tab and its periphery to 20°C or higher prior to works. When the mirror is heated too quickly from its cold state, it may be broken.

1.Disengage the tab behind the mirror from the door mirror housing.
2.Disconnect the connectors of the heated mirror.

<<B>> DOOR MIRROR MAIN HARNESS CONNECTOR REMOVAL

1.Remove the tape around the wiring harness shown in the illustration.
2.Pull out all of the terminals from the connector.

INSTALLATION SERVICE POINT

>>A<< DOOR MIRROR MAIN HARNESS CONNECTOR INSTALLATION

1.Check the wire colour of the wiring harness, and insert it into the connector as shown in the illustration.

note

Wire colours are indicated by alphabets as shown in the table.

Code	Wire colour	Code	Wire colour	Code	Wire colour	Code	Wire colour
B	Black	L	Blue	PU	Purple	V	Violet
BR	Brown	LG	Light green	R	Red	W	White
G	Green	O	Orange	SB	Sky blue	Y	Yellow
GR	Grey	P	Pink	SI	Silver	BE	Beige

2.Fix the base assembly and the wiring harness at the position of the specified length with a new tape.