INSPECTION


REMOTE CONTROLLED DOOR MIRROR OPERATION CHECK


Remove the door trim, and then connect the battery to the door mirror assembly connector to check that the door mirror operates.

Battery connection
 Operation direction

  • Connect terminal No. 12 to the negative battery terminal.
  • Connect terminal No. 5 to the positive battery terminal.

 Up

  • Connect terminal No. 12 to the positive battery terminal.
  • Connect terminal No. 5 to the negative battery terminal.

 Down

  • Connect terminal No. 13 to the negative battery terminal.
  • Connect terminal No. 12 to the positive battery terminal.

 Right

  • Connect terminal No. 13 to the positive battery terminal.
  • Connect terminal No. 12 to the negative battery terminal.

 Left

  • Connect terminal No. 11 to the positive battery terminal.
  • Connect terminal No. 4 to the negative battery terminal.

 Retract

  • Connect terminal No. 11 to the negative battery terminal.
  • Connect terminal No. 4 to the positive battery terminal.

 Extend

REMOTE CONTROLLED MIRROR SWITCH CONTINUITY CHECK

Switch position
 Tester connection
 Specified condition
Left side
 Up
 1 - 6, 9 - 11
 Continuity
exists(2 Ω or less)
Down
 1 - 11, 6 - 9
Right
 1 - 6, 9 - 10
Left
 1 - 10, 6 - 9
Right side
 Up
 1 - 6, 3 - 9
Down
 1 - 3, 6 - 9
Right
 1 - 6, 2 - 9
Left
 1 - 2, 6 - 9
Retract and extend
 1 - 4

HEATED DOOR MIRROR CHECK
caution When relocating the car between locations with extremely different temperatures (warm and cold), leave the car in the location for a while to adapt to the temperature prior to checking it.

Check that the resistance value between the door mirror assembly connector terminal Nos. 1 and 9 is at the standard value.
Standard value: 7.2 ± 1.4 Ω at 25°C

BLIND SPOT WARNING LAMP CHECK

Blind spot warning lamp check

1.
caution Do not apply battery voltage to door mirror assembly connector No. 3 terminal as the blind spot warning lamp is broken.
Apply 5V to the door mirror assembly connector terminal No. 3, earth the terminal No. 11, and then check that the illumination lights up.

2.
caution Do not apply battery voltage to blind spot warning lamp connector No. 1 terminal as the blind spot warning lamp is broken.
Apply 5V to the blind spot warning lamp connector terminal No. 1, earth the terminal No. 2, and then check that the illumination lights up.

Checking the door mirror main wiring harness wires for continuity
Check the continuity between the door mirror assembly connector and the blind spot warning lamp connector.
Circuit
 Tester connection
 Specified condition
Power supply
 Door mirror assembly connector terminal No. 3 - blind spot warning lamp connector terminal No. 1
 Continuity
exists(2 Ω or less)
Earth
 Door mirror assembly connector terminal No. 11 - blind spot warning lamp connector terminal No. 1