REMOVAL AND INSTALLATION


caution
  • Disconnect the negative (-) battery terminal and wait for 60 seconds or more before starting work. Insulate the disconnected (-) terminal by wrapping the tape (Refer to the item 5 of Service Precautions ).
  • Never attempt to disassemble or repair the side impact sensor. If damaged, replace it with new one(s).
  • Handle the side impact sensor with sufficient caution, and do not drop or subject the sensor to impact or vibration. If there is a dent, crack, or deformation, replace with a new sensor.
  • After the side/curtain air bag deployment, replace with a new sensor.
Pre-removal operation
  • Turn the ignition switch to the LOCK (OFF) position.
  • Disconnect the negative (-) battery terminal.




Side impact sensor removal steps


·
 Centre pillar trim lower (Refer to GROUP 52A - Interior Trim ).


·
 Seat belt with pre-tensioner (Refer to ).
<<A>>

1.
 Side impact sensor



Side impact sensor installation steps

>>A<<
 ·
 Pre-installation inspection

>>B<<
 1.
 Side impact sensor


·
 Seat belt with pre-tensioner (Refer to ).


·
 Centre pillar trim lower (Refer to GROUP 52A - Interior Trim ).

>>C<<
 ·
 Post-installation inspection

REMOVAL SERVICE POINT

<<A>> SIDE IMPACT SENSOR CONNECTOR REMOVAL

Slide the outer housing of the side impact sensor connector in the arrow direction shown, and disconnect the connector.

INSTALLATION SERVICE POINTS

>>A<< PRE-INSTALLATION INSPECTION
Even when installing a new side impact sensor, perform an inspection before the installation (Refer to the item on inspection).

>>B<< SIDE IMPACT SENSOR INSTALLATION
caution If the side impact sensor is not securely and correctly installed, the correct operation of side/curtain air bag is prevented.
Connect the connector securely.

>>C<< POST-INSTALLATION INSPECTION
1.Turn the ignition switch to the "ON" position.

2.Check that the SRS warning lamp is illuminated for 6 to 8 seconds, and extinguished afterward.
3.If the lamp does not extinguish, perform the troubleshooting.