Code No. B2510
Height Sensor Not Initialized
caution |
- If there is any
problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis,
always diagnose the CAN bus lines.
- Before replacing the ECU, ensure that the power supply circuit, the earth circuit
and the communication circuit are normal.
- When the ETACS-ECU of vehicles without KOS is replaced, the encrypted code of the ignition
key needs to be registered to the ETACS-ECU. (If the encrypted code is not registered, the engine
cannot be started. Register the encrypted code as described in Immobilizer System - How
to Register Key ID
.)
|
DIAGNOSTIC FUNCTION
When the headlamp automatic levelling system initialization * is not
implemented, the code No. B2510 is stored. When the headlamp automatic levelling system initialization
is completed, the code No. B2510 is cleared automatically.
note |
*: When the height sensor related diagnosis code (B2514, B2515 or
B2516) or ETACS-ECU related diagnosis code (B2215 or U0331) is set, initialization of the headlamp
automatic levelling system is impossible, therefore perform the troubleshooting for the diagnosis
code that has been set previously.
|
JUDGEMENT CRITERIA
Initialization of the headlamp automatic levelling system is not completed.
PROBABLE CAUSES
- Headlamp automatic levelling system initialization not completed
- Malfunction of the ETACS-ECU
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnostics
Use the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting
).
STEP 2. M.U.T.-III diagnosis code
Check if the height sensor related diagnosis code (B2514, B2515 or B2516) or the ETACS-ECU
related diagnosis code (B2215 or U0331) is set.
Q.
Is the diagnosis code set?
Perform the troubleshooting of the diagnosis code that has been set previously.
Go to Step 3.
STEP 3. Check whether the diagnosis code is reset.
Initialise the headlamp automatic levelling system and check the diagnosis code of the
ETACS-ECU.
|
(1)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
|
|
(2)Initialise the headlamp automatic levelling system. Refer to .
|
|
(3)Check if diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the ETACS-ECU.
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How
to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction
).