![](../../../img/54/AC804645AB00ENG.png)
![](../../../img/54/ACB05774AB00ENG.png)
|
1.
caution |
When marking the aiming
adjustment, be sure to mask those lamps which
are not being adjusted.
|
Measure the centre of the front fog lamps, as shown
in the illustration. 2.Set the distance between
the screen and the centre of the front fog lamps as shown
in the illustration. 3.Inflate the types to the
specified pressures and there should be no other load in
the vehicles other than driver or substituted weight of
approximately 75 kg placed in the driver’s
position. 4.With the engine running at 2,000
r/min, aim the front fog lamp. 5.Insert a
Phillips screwdriver into the service hole and place it on
the adjusting
screw.
|
![](../../../img/54/AC312871AB00ENG.png)
|
6.
caution |
Be sure to adjust the aiming
adjustment screw in the tightening
direction.
|
Adjust the cut off line (boundary between light and
dark) position to the standard value
with the adjusting screw. Standard
value: Vertical direction; 60 mm (1.15°) below
horizontal (H) Limit: Vertical
direction; 39 mm (0.75°) to 89 mm (1.7°)
below the horizontal
(H)
note |
The horizontal direction is
non-adjustable.
|
|