|
1.
caution |
When marking the aiming
adjustment, be sure to mask those lamps which
are not being adjusted.
|
Measure the centre of the front fog lamps, as shown
in the illustration. 2.Set the distance between
the screen and the centre of the front fog lamps as shown in
the illustration. 3.Inflate the types to the
specified pressures and there should be no other load in the
vehicles other than driver or substituted weight of
approximately 75 kg placed in the driver’s
position. 4.With the engine running at 2,000
r/min, aim the front fog lamp. 5.Removal the
front fog lamp bezel and front fog lamp bezel ring (Refer to
).
|
|
6.Insert a Phillips
screwdriver into the adjusting screw.
|
|
7.
caution |
Be sure to adjust the aiming
adjustment screw in the tightening
direction.
|
Adjust the cut off line (boundary between light and
dark) position to the standard value with the adjusting
screw. Standard value: Vertical direction;
60 mm (1.15°) below horizontal
(H) Limit: Vertical direction; 45 mm
(0.86°) to 99 mm (1.9°) below the horizontal
(H)
note |
The horizontal direction is
non-adjustable.
|
|