Fault
type
|
Monitor
screen
|
Causes
|
Entire screen is
black
|
The
entire screen is black.
|
The camera-ECU
fails. (diagnosis code No.B2541, B2544 is set)
|
Entire screen is
blue <vehicles without display audio and
MMCS>
|
The
entire screen is blue.
|
A blue screen may
be caused by an external noise. When the inside rear view
mirror receives an error signal, the entire monitor section
will be displayed in blue, and then disappear in three
seconds. If the mirror receives a normal signal
again, the monitor section will be resumed.
|
Screen
freeze
|
Entire
camera image is grey.
|
Screen transition
does not progress (diagnosis code No.B254E is set)
|
Interrupted
screen
|
<Bird’s
eye-view and front-view>
<Side-view
and front-view>
Some
of the camera images (segments) are not displayed (partially
blue).
|
Either of the
cameras fails (diagnosis code No.B2501, B2503, B2546,
B2547 or B254B is set).
note |
The left figure shows that the
front camera fails.
|
|
Not
calibrated
|
<Bird’s
eye-view and front-view>
<Side-view
and front-view>
"!"
will be displayed on the camera image, which has not been
calibrated yet.
|
Any of the cameras
has not been calibrated yet. (diagnosis code No.B2542
or B2548 is set)
note |
"!" mark may be displayed due
to an failure in ASIC external flashing even if
diagnosis
code No.B2542 or B2548 is not set. If the
calibration has not been completed successfully,
replace
the camera-ECU and calibrate it again.
|
|
Replacement of the
ECU
|
"x"
mark is displayed on the vehicle icon.
|
The camera-ECU
fails. (diagnosis code No.B2505, B2540, B2543 or B2544
is set)
|
Confirm how the
data is configured
|
"!"
mark is displayed on the vehicle icon.
|
The camera-ECU
fails. (diagnosis code No.U1195, U1197 is set)
note |
When the vehicle information
data is not registered in the camera-ECU
(diagnosis code
No.U1195 is set), neither the line A nor B is
not displayed.
|
|
Error on CAN
message
|
"Thunder"
mark is displayed on the vehicle icon.
|
Any fault(s) other
than the steering angle exist in the CAN communication.
(diagnosis
code No.U0100 is set)
|
"Thunder"
mark is displayed on the vehicle icon.
|
A fault on the
steering angle information exists in the CAN communications.
(diagnosis
code No.B254A or U0126 is set)
|