Code No.U1197
Coding data unavailable
| caution |
If diagnosis code No.U1197
is set, be sure to diagnose the CAN bus line.
|
TROUBLE JUDGEMENT
This diagnosis code will be set when the variant coding for the ETACS-ECU has not been implemented.
| note |
"!" mark is displayed on the vehicle icon when diagnosis code No.U1197 is set.
|
PROBABLE CAUSES
- Variant coding not performed
- Malfunction of ETACS-ECU
- Malfunction of camera-ECU
- Malfunction of CAN bus
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnostics.
Use the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting).
STEP 2. M.U.T.-III other system diagnosis code.
Check if diagnosis code is set in the ETACS-ECU.
Q.
Is the diagnosis code set?
Diagnose the ETACS.
Go to Step 3.
STEP 3. ETACS-ECU coding data check.
Using M.U.T.-III, check if any abnormality is present to the coding data which are stored
in the ETACS-ECU.
Q.
Is the check result normal?
Go to Step 4.
Replace the ETACS-ECU.
STEP 4. Diagnosis code recheck.
Check again if the diagnosis code is set in the camera-ECU.
|
|
(1)Erase the diagnosis code.
|
|
|
(2)Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
|
|
|
(3)Check if the diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the camera-ECU (Refer to 
).
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How
to Use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction).