Code No. U0141
ETACS CAN timeout
caution |
- If the diagnosis
code No. U0141 is set, be sure to diagnose the CAN bus line.
- Before replacing the ECU or sensor, ensure that the power supply circuit, the earth
circuit and the communication circuit are normal.
- When the ETACS-ECU of vehicles without KOS is replaced, the encrypted code of the ignition
key needs to be registered to the ETACS-ECU. (If the encrypted code is not registered, the engine
cannot be started. Register the encrypted code as described in Immobilizer System - How
to Register Key ID
.)
- When the illuminated licence plate is installed, the sensors may not operate because
of noise from the plate. (When the ultrasonic noise is received, the bass toned buzzer sound
continuously. When the ultrasonic noise stops, the normal operation will be resumed immediately.)
|
DIAGNOSTIC FUNCTION
The corner sensor/back sensor-ECU sets diagnosis code No.U0141 when it cannot receive
signals from the ETACS-ECU.
JUDGEMENT CRITERIA
The corner sensor/back sensor-ECU cannot receive the signal from the ETACS-ECU via the
CAN bus line.
PROBABLE CAUSES
- Malfunction of CAN bus line
- Malfunction of ETACS-ECU
- Malfunction of corner sensor/back sensor-ECU
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnostics
Use the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting - CAN
Bus Diagnosis Chart
).
STEP 2. Check the M.U.T.-III Diagnosis code for other systems
Check if the diagnosis code No. U0141 is set to engine-ECU.
Q.
Is the diagnosis code set?
Go to Step 3.
Go to Step 4.
STEP 3. Diagnosis code recheck
Check again if the diagnosis code is set to the corner sensor/back sensor-ECU.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from the LOCK (OFF) position to the ON position.
|
|
(3)Check if the diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the ETACS-ECU.
A poor connection, open circuit, or other intermittent malfunction in the CAN
bus line between the corner sensor/back sensor-ECU and the ETACS-ECU (Refer to GROUP 00 - How
to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction
).
STEP 4. Diagnosis code recheck
Check again if the diagnosis code is set to the corner sensor/back sensor-ECU.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from the LOCK (OFF) position to the ON position.
|
|
(3)Check if the diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the corner sensor/back sensor-ECU.
A poor connection, open circuit, or other intermittent malfunction in the CAN
bus line between the corner sensor/back sensor-ECU and the ETACS-ECU (Refer to GROUP 00 - How
to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction
).