Code No. U1005 Corner/Back
SNS.ECU CAN timeout
caution |
- If diagnosis
code No. U1005 is set to the ETACS-ECU, always diagnose the CAN bus line.
- Before replacing the ECU, ensure that the power supply circuit, the earth circuit
and the communication circuit are normal.
- When the ETACS-ECU of vehicles without KOS is replaced, the encrypted code of the ignition
key needs to be registered to the ETACS-ECU. (If the encrypted code is not registered, the engine
cannot be started. Register the encrypted code as described in Immobilizer System - How
to Register Key ID .)
|
DIAGNOSTIC FUNCTION
If the signal from corner sensor/back sensor-ECU cannot be received, the ETACS-ECU sets
the diagnosis code No. U1005.
JUDGEMENT CRITERIA
After the following statuses continue to be true for 5 seconds, if the communication with
the corner sensor/back sensor-ECU cannot be established for 600 ms or more, the ETACS-ECU determines
that a problem has occurred.
- No abnormality is present to the network.
- Ignition switch is in the ON position.
- No abnormality is present to the power supply fuse (IOD fuse), or the odometer value
is at 80.5 km or more.
- ETACS-ECU system voltage is at 10-16 V.
PROBABLE CAUSES
- Malfunction of the corner sensor/back sensor-ECU
- Malfunction of the ETACS-ECU
- Malfunction of the CAN bus
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnostics
Use M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 2.
Repair the CAN bus lines. (Refer to GROUP 54C - Troubleshooting .)
STEP 2. Check the M.U.T.-III Diagnosis code for other systems
Check if a diagnosis code is set to the corner sensor/back sensor-ECU.
Q.
Is the diagnosis code set?
Perform troubleshooting for the corner sensor/back sensor-ECU. (Refer to .)
Go to Step 3.
STEP 3. Check whether the diagnosis code is reset.
Check again if the diagnosis code is set to ETACS-ECU.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from the LOCK (OFF) position to the ON position.
|
|
(3)Check if the diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the corner sensor/back sensor-ECU. Go to Step 4.
A poor connection, open circuit, or other intermittent malfunction in the CAN
bus line between the corner sensor/back sensor-ECU and ETACS-ECU. (Refer to GROUP 00 - How
to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction .)
STEP 4. Check whether the diagnosis code is reset.
Check again if the diagnosis code is set to ETACS-ECU.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from the LOCK (OFF) position to the ON position.
|
|
(3)Check if the diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the ETACS-ECU.
A poor connection, open circuit, or other intermittent malfunction in the CAN
bus line between the corner sensor/back sensor-ECU and ETACS-ECU. (Refer to GROUP 00 - How
to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction .)