Code No.U1109
Column SW LIN timeout
caution |
Before replacing the ECU,
ensure that the communication circuit is normal.
|
JUDGMENT CRITERIA
The ETACS-ECU will set diagnosis code No. U1109 when no signals are received from the
column switch (column switch ECU).
PROBABLE CAUSES
- Faulty wiper and washer switch <RHD>
- Faulty lighting switch <LHD>
- Malfunction of the LIN bus
|
STEP 1. Resistance measurement at the column switch connector
|
|
(1)Disconnect the connector, and measure at the wiring harness side.
|
|
(2)Measure the resistance between the column switch connector (earth terminal) and
the body earth. OK: Continuity exists (2 Ω or less)
|
|
Q.
Is the check result normal?
|
|
Go to Step 3.
|
|
|
|
Go to Step 2.
|
|
|
|
STEP 2. Check of open circuit in body earth line between column switch
connector (earth terminal) and the body earth.
|
|
Q.
Is the check result normal?
|
|
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How
to use Troubleshooting/inspection Service Points - How to Cope with Intermittent
Malfunction ).
|
|
|
|
Repair the connector(s) or wiring harness.
|
|
|
|
STEP 3. Voltage measurement at the column switch connector.
|
|
(1)Disconnect the connector, and measure at the wiring harness side.
|
|
(2)Measure the voltage between the column switch connector (power supply terminal)
and the body earth. OK: System voltage
|
|
Q.
Is the check result normal?
|
|
Go to Step 5.
|
|
|
|
Go to Step 4.
|
|
|
|
STEP 4. Check of short to power supply, short to earth, and open circuit
in BUP1 line between ETACS-ECU connector and column switch connector.
|
|
Q.
Is the check result normal?
|
|
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How
to use Troubleshooting/inspection Service Points - How to Cope with Intermittent
Malfunction ).
|
|
|
|
Repair the connector(s) or wiring harness.
|
|
|
|
STEP 5. Check of open circuit in DATA line between ETACS-ECU connector
and column switch connector.
|
|
Q.
Is the check result normal?
|
|
Go to Step 6.
|
|
|
|
Repair the connector(s) or wiring harness.
|
|
|
|
STEP 6. Check whether the diagnosis code is reset.
|
|
Check again if the diagnosis code is set to the ETACS-ECU.
|
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
|
|
(3)Check if diagnosis code is set.
|
|
Q.
Is the diagnosis code set?
|
|
Replace the wiper/washer switch <RHD> or lighting switch <LHD>.
|
|
|
|
A poor connection, open circuit, or other intermittent malfunctions in the LIN
bus lines between the column switch and the ETACS-ECU (Refer to GROUP 00 - How to Cope with
Intermittent Malfunction ).
|
|
|