Code No.U0169 Sunroof LIN timeout <Vehicles with sunroof>
caution |
Before replacing the ECU, ensure that the communication circuit is normal.
|
JUDGEMENT CRITERIA
The ETACS-ECU will set diagnosis code No. U0169 when no signals are received from the sunroof motor assembly.
PROBABLE CAUSES
- Faulty sunroof motor assembly
- Malfunction of the LIN bus
|
STEP 1. Resistance measurement at the sunroof motor assembly connector
|
|
(1)Disconnect the connector, and measure at the wiring harness side.
|
|
(2)Measure the resistance between the sunroof motor assembly connector (earth terminal) and the body earth. OK: Continuity exists (2 Ω or less)
|
|
Q.
Is the check result normal?
|
|
Go to Step 3.
|
|
|
|
Go to Step 2.
|
|
|
|
STEP 2. Check of open circuit in body earth line between sunroof motor assembly connector (earth terminal) and the body earth.
|
|
Q.
Is the check result normal?
|
|
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).
|
|
|
|
Repair the connector(s) or wiring harness.
|
|
|
|
STEP 3. Voltage measurement at the sunroof motor assembly connector.
|
|
(1)Disconnect the connector, and measure at the wiring harness side.
|
|
(2)Measure the voltage between the sunroof motor assembly connector (power supply terminal) and the body earth. OK: System voltage
|
|
Q.
Is the check result normal?
|
|
Go to Step 5.
|
|
|
|
Go to Step 4.
|
|
|
|
STEP 4. Check of short to power supply, short to earth, and open circuit in SR+ line between ETACS-ECU connector and sunroof motor assembly connector.
|
|
Q.
Is the check result normal?
|
|
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).
|
|
|
|
Repair the connector(s) or wiring harness.
|
|
|
|
STEP 5. Check of open circuit in LIN2 line between ETACS-ECU connector and sunroof motor assembly connector.
|
|
Q.
Is the check result normal?
|
|
Go to Step 6.
|
|
|
|
Repair the connector(s) or wiring harness.
|
|
|
|
STEP 6. Check whether the diagnosis code is stored again.
|
|
Check again if the diagnosis code is stored in the ETACS-ECU.
|
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from the LOCK (OFF) position to the ON position.
|
|
(3)Check if diagnosis code is stored.
|
|
Q.
Is the diagnosis code stored?
|
|
Replace the sunroof motor assembly.
|
|
|
|
A poor connection, open circuit, or other intermittent malfunctions in the LIN bus lines between the sunroof motor assembly and the ETACS-ECU (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).
|
|
|