Diagnosis Item 27: Diagnose the lines between the joint connectors (CAN1 and CAN2). <Vehicles with ACC>
caution |
When servicing a CAN bus line, earth yourself by touching a metal object such as an unpainted water pipe. If you fail to do, a component connected to the CAN bus line may be broken.
|
FUNCTION
The diagnostic result demonstrates that "diagnose the lines between the joint connectors (CAN1 and CAN2)" when the M.U.T.-III checks the periodically sent data from each ECU and cannot receive the engine-ECU data.
TROUBLE JUDGEMENT CONDITIONS
M.U.T.-III judges the trouble when the periodically sent data from engine-ECU cannot be received.
PROBABLE CAUSE
Damaged harness wires and connectors
|
STEP 1. Connector check: joint connector (CAN1) and joint connector (CAN2)
|
|
caution |
The strand end of the twist wire should be within 10 cm from the connector.
|
|
|
When checking the joint connector, ensure that its wiring harness side and its short pins are not damaged.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Repair the defective connector. Replace the joint connector as necessary.
|
|
|
|
STEP 2. Resistance measurement at joint connector (CAN1) and joint connector (CAN2).
|
|
caution |
A digital multimeter should be used.
|
|
|
caution |
The test wiring harness should be used.
|
|
|
(1)Disconnect the joint connector (CAN1) and the joint connector (CAN2), and measure at the wiring harness side.
|
|
(2)Turn the ignition switch to the LOCK (OFF) position.
|
|
(3)
caution |
When measuring the resistance, disconnect the negative battery terminal.
|
Ensure that the negative battery terminal is disconnected.
|
|
(4)Continuity between joint connector (CAN1) terminal No.8 and joint connector (CAN2) terminal No.11 OK: Continuity (2 Ω or less)
|
|
(5)Continuity between joint connector (CAN1) terminal No.17 and joint connector (CAN2) terminal No.22 OK: Continuity (2 Ω or less)
caution |
Strictly observe the specified wiring harness repair procedure.
|
|
|
Q.
Is the check result normal?
|
|
<All the resistances measure 2 Ω or less> Follow diagnosis item 23, 24, 25, 26, 28 and 29. Refer to .
|
|
|
|
NO : <Either or all of the resistances measure more than 2 Ω> Repair the wiring harness between joint connector (CAN1) and joint connector (CAN2).
|
|
|