CODE No. C2334
SAS neutral point not learned
caution |
Before replacing the ECU,
ensure that the power supply circuit, the earth circuit and the communication circuit are normal.
|
OPERATION
The BSW-ECU (slave) communicates with the steering wheel sensor via the gateway-ECU, the BSW-ECU
(master) and the CAN bus lines.
CHECK CONDITION
Ignition switch is in the ON position.
DIAGNOSTIC FUNCTION AND JUDGEMENT CRITERIA
When the BSW-ECU (slave) receives the signal, which indicates that the neutral position
of the steering wheel sensor has not been learnt yet, the ECU will set diagnosis code No.C2334.
PROBABLE CAUSES
- Neutral position of steering wheel sensor not learned
- Malfunction of the steering wheel sensor (incorporated in column switch assembly)
- Malfunction of BSW-ECU (master/slave)
DIAGNOSIS PROCEDURE
STEP 1. Check whether the BSW-ECU (master) sets a diagnosis code.
Check if diagnosis code No. C2334 is set in the BSW-ECU (master).
Q.
Is the diagnosis code set?
Troubleshoot the BSW-ECU (master) (Refer to
).
Go to Step 2.
STEP 2. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the BSW-ECU (slave).
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from the LOCK (OFF) position to the ON position.
|
|
(3)Check if the diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the BSW-ECU (slave). Then Go to Step 3.
Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use
Troubleshooting/Inspection Service Points - How to cope with Intermittent Malfunction).
STEP 3. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the BSW-ECU (slave).
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from the LOCK (OFF) position to the ON position.
|
|
(3)Check if the diagnosis code is set.
|
Q.
Is the diagnosis code set?
Use the BSW-ECU (slave), which has been removed at step 2, as the BSW-ECU (master).
This diagnosis is complete.