|
1.Assemble a gauge manifold
on the high pressure service valve.
|
|
2.Disconnect the A/C
pressure sensor connector and connect the special tool test
harness (MB991658) as shown. 3.Start the engine
and then turn ON the air conditioner switch.
|
|
4.At this time, check to see
that the voltage of the A/C pressure sensor connector
terminal No. 2 reflects the specifications of the
figure.
note |
- The allowance shall be defined as
±5%.
- The A/C pressure sensor is
incorporated in the discharge flexible
hose,
and the high-pressure service valve is
incorporated in liquid pipe B.
Therefore, the pressure
at the A/C pressure sensor is 0.1
to 0.3 MPa higher than that at the gauge
manifold.
|
|