REMOVAL AND INSTALLATION

			Crankshaft front oil removal steps
		·	Crankshaft pulley (Refer to .)
		1.	Crankshaft front oil seal
			Crankshaft rear oil seal removal steps <M/T>
		·	Transmission assembly (Refer to GROUP 22A - Transmission assembly ).
		·	Clutch cover and clutch disc (Refer to GROUP 21B - Clutch ).
<<A>>	>>B<<	2.	Flywheel bolt
		3.	Flywheel assembly
		8.	Crankshaft rear oil seal
			Crankshaft rear oil seal removal steps <A/T>
		·	Transmission assembly (Refer to GROUP 23A - Transmission assembly ).
<<A>>	>>B<<	4.	Drive plate bolt
	>>A<<	5.	Adapter plate
	>>A<<	6.	Drive plate
	>>A<<	7.	Crankshaft adapter
		8.	Crankshaft rear oil seal

REMOVAL SERVICE POINT

<<A>> FLYWHEEL BOLT <M/T>/DRIVE PLATE BOLT <A/T> REMOVAL

1.Use special tool flywheel stopper (MD998781) to secure the flywheel assembly <M/T> or drive plate <A/T>.
2.Remove the flywheel bolts <M/T> or drive plate bolts <A/T>.

INSTALLATION SERVICE POINTS

>>A<< CRANKSHAFT ADAPTER/DRIVE PLATE/ADAPTER PLATE INSTALLATION

Assemble the crankshaft adapter and the adapter plate to the drive plate as shown, and then install the drive plate into the crankshaft.

>>B<< DRIVE PLATE BOLT <A/T>/FLYWHEEL BOLT <M/T> INSTALLATION

1.Use special tool flywheel stopper (MD998781) to secure the drive plate <A/T> or flywheel assembly <M/T> in the same manner as removal.
2.Tighten the drive plate bolts <A/T> or flywheel bolts <M/T> to the specified torque.
Tightening torque:

123 N·m <M/T>
135 ± 5 N·m <A/T>