|
1.Check for oil leak from
seal, and replace it if leak is detected. 2.Check
for wear or damage at the top of the rod. Replace it, if
required.
|
|
3.While holding the timing
belt tensioner adjuster with your hand, press the end of the
pushrod against a metal surface (such as the cylinder block)
with a force of 98 - 196 N and measure how far the
pushrod is pushed in.
Standard
value: Within 1 mm A: Length when no force is
applied B: Length when force is applied A
- B: Movement in
4.If the
measured value is out of the standard value, replace the
timing belt tensioner adjuster.
|