|
1.Using special tool
Flywheel stopper (MD998781), hold the drive plate or
flywheel. 2.Remove the crankshaft bolt.
|
|
1.Using special tool
Flywheel stopper (MD998781), hold the drive plate or
flywheel.
|
|
2.Using a rag, wipe dirt on
the crankshaft thread hole and the crankshaft pulley
washer. 3.Using a rag, wipe dirt on the crankshaft
pulley and then degrease the place specified
in the illustration.
note |
Perform degreasing to prevent
the friction resistance from decreasing in the
compressed area
due to the residual oil.
|
4.Install the crankshaft
pulley. 5.Apply the minimum amount of engine oil
to the crankshaft bolt threads and the seating
surface. 6.Turning the inside chamfer side of the
crankshaft pulley washer toward the bolt head,
install the crankshaft pulley washer to the crankshaft
bolt. 7.Tighten the crankshaft bolt to the
specified torque of 185 N·m.
|
|
Tighten the timing indicator
bracket bolt of 11 ± 1 N·m.
|