REMOVAL AND INSTALLATION



Removal steps


1.
 Cooling fan


2.
 Fan clutch


3.
 Cooling fan pulley


4.
 Cooling fan bracket


5.
 Idler pulley


6.
 Idler pulley


7.
 Auto tensioner


8.
 Alternator


9.
 Accessory mount stay

>>B<<
 10.
 Timing indicator bracket


11.
 Accessory mount
<<A>>
 >>A<<
 12.
 Crankshaft bolt


13.
 Crankshaft pulley washer


14.
 Damper pulley

REMOVAL SERVICE POINT

<<A>> CRANKSHAFT BOLT REMOVAL

1.Using special tool Flywheel stopper (MD998781), hold the drive plate or flywheel.
2.Remove the crankshaft bolt.

INSTALLATION SERVICE POINT

>>A<< CRANKSHAFT BOLT TIGHTENING

1.Using special tool Flywheel stopper (MD998781), hold the drive plate or flywheel.

2.Using a rag, wipe dirt on the crankshaft thread hole and the crankshaft pulley washer.
3.Using a rag, wipe dirt on the crankshaft pulley and then degrease the place specified in the illustration.
note Perform degreasing to prevent the friction resistance from decreasing in the compressed area due to the residual oil.
4.Install the crankshaft pulley.
5.Apply the minimum amount of engine oil to the crankshaft bolt threads and the seating surface.
6.Turning the inside chamfer side of the crankshaft pulley washer toward the bolt head, install the crankshaft pulley washer to the crankshaft bolt.
7.Tighten the crankshaft bolt to the specified torque of 185 N·m.

>>B<< TIMING INDICATOR BRACKET
caution
  • Install harness bracket together when installing timing indicator bracket.
  • Harness shall be not to sag between.
Tighten the timing indicator bracket bolt of 11 ± 1 N·m.