REMOVAL AND INSTALLATION

			Removal steps
		1.	Spark plug cables
		2.	Spark plugs
		3.	Camshaft position sensor
		4.	O-ring
	>>B<<	5.	Camshaft position sensor support
<<A>>	>>A<<	6.	Camshaft position sensing cylinder

REMOVAL SERVICE POINT

<<A>> CAMSHAFT POSITION SENSING CYLINDER

1.Lock the drive plate or flywheel using the special tool Flywheel stopper (MD998781).
2.Then loosen the crankshaft bolts.

INSTALLATION SERVICE POINT

>>A<< CAMSHAFT POSITION SENSING CYLINDER INSTALLATION

1.Lock the drive plate or flywheel using the special tool Flywheel stopper (MD998781).
2.Tighten the camshaft position sensing cylinder bolt to the specified torque of 22 ± 4 N·m.

>>B<< CAMSHAFT POSITION SENSOR SUPPORT INSTALLATION

1.Completely remove existing form-in-place gasket from the cam position sensor support and cylinder head (surface to which cam position sensor support is fitted).
2.Apply a 3 mm bead of form-in-place gasket (FIPG) to the area shown.
Specified sealant:
Mitsubishi Genuine Part No.MD970389 or equivalent