|
1.Remove the bolts A shown
in the illustration first. 2.Remove all other
bolts. 3.
caution |
Do not use a scraper or
special tool to remove the oil
pan.
|
Remove the oil pan.
|
|
4.Thread the bolt into the
illustrated bolt hole to remove the oil pan.
|
|
Make alignment dots on the outer
and inner rotors for assembly.
|
|
Apply engine oil to the rotors.
Then, install the rotors ensuring that the alignment dots
made at disassembly are properly aligned.
|
|
1.Install the guide of
special tool Crankshaft front oil seal installer (MD998717)
to the
front end of the crankshaft. 2.Apply engine oil to
the lip area of a new oil seal and push it in until it
contacts
the oil pump case.
|
|
3.Using special tool
Crankshaft front oil seal installer (MD998717), press-fit
the oil seal
into the oil pump case.
|
|
1.Clean the gasket surfaces
of the cylinder block and upper oil pan. 2.Apply a
4 mm diameter bead of sealant to the oil pan. Be sure to
install the oil pan
quickly while the sealant is wet (within 15
minutes). Specified
sealant:
Mitsubishi Genuine Part
No.MD970389 or equivalent
|
|
3.
caution |
When installing the upper oil
pan, be sure not to expel
the sealant from the oil pan flange at portion A
in the illustration.
|
Tighten the upper oil pan bolts in the sequence
shown to specified torque of 9.0 ±
3.0
N·m. 4.After installation, keep the sealed
area away from the oil and coolant for approximately
one hour.
|
|
caution |
If the gasket is installed in
the wrong direction, oil leaks will be
occurred.
|
Install the drain plug gasket as
illustrated.
|
|
1.Clean the installation
surface of the filter bracket. 2.Apply engine oil
to the O-ring of the oil filter. 3.Screw the oil
filter on until the O-ring contacts the bracket. Then
tighten 3/4
turn (14 ±
1 N·m)
|
|
1.
caution |
Keep the end of threaded
portion clear of sealant. Avoid an
overtightening.
|
Apply sealant to the oil pressure switch
threads. Specified sealant: 3MTM
AAD Part No. 8672 or equivalent
|