INSPECTION


OIL PUMP
1.Shaft to oil pump case and cover clearances.
in either case, if the measurement exceeds the specified service limit, replace oil assembly.

    Standard value: 0.03 - 0.05 mm
    Limit: 0.15 mm

2.Difference between gear height and oil pump case depth.
If the difference exceeds the specified service limit, replace defective part.

    Standard value: 0.05 - 0.10 mm
    Limit: 0.15 mm

3.Gear tooth crest to oil case clearance.
If clearance exceeds the specified service limit, replace defective part.

    Standard value: 0.15 - 0.26 mm
    Limit: 0.27 mm

REAR BEARING

Measure the balance shaft-to-balance shaft bush clearance if the reading exceeds the specified service limit, replace defective part.

    Standard value: 0.06 - 0.11 mm
    Limit: 0.16 mm

IDLER GEAR BUSH LH AND IDLER SHAFT A

Measure the idler shaft-to-idler gear bush clearance.If the reading exceeds the specified service limit, replace defective part.

    Standard value: 0.02 - 0.05 mm
    Limit: 0.1 mm

IDLER SPROCKET BUSH AND IDLER SHAFT

Measure the idler shaft-to-idler sprocket bush clearance.If the reading exceeds the specified service limit, replace defective part.

    Standard value: 0.02 - 0.06 mm
    Limit: 0.1 mm