REMOVAL AND INSTALLATION

			Removal steps
		1.	Drive belt
		2.	Cooling fan
		3.	Fan clutch
		4.	Plate
		5.	Water pump pulley
<<A>>	>>A<<	6.	Crankshaft pulley bolt
	>>A<<	7.	Crankshaft pulley bolt washer
	>>A<<	8.	Crankshaft pulley
		9.	Alternator
		10.	Alternator brace
		11.	Oil level gauge
		12.	Oil level gauge guide
		13.	O-ring
		14.	Oil level gauge guide bracket

REMOVAL SERVICE POINTS

<<A>> CRANKSHAFT PULLEY BOLT REMOVAL

1.Use the special tool Flywheel stopper (MD998781), hold the flywheel or drive plate.
2.Remove the crankshaft pulley bolt.

INSTALLATION SERVICE POINTS

>>A<< CRANKSHAFT PULLEY BOLT / CRANKSHAFT PULLEY BOLT WASHER / CRANKSHAFT PULLEY INSTALLATION

1.Use the special tool Flywheel stopper (MD998781), hold the flywheel or drive plate.

2.Using a rag, wipe dirt on the crankshaft thread hole and the crankshaft pulley washer.
3..Using a rag, wipe dirt on the crankshaft pulley and then degrease the place specified in the illustration

note

Perform degreasing to prevent the friction resistance from decreasing in the compressed area due to the residual oil.

4.Install the crankshaft pulley.
5.Apply the minimum amount of engine oil to the crankshaft bolt threads and the seating surface.
6.Turning the inside chamfer side of the crankshaft pulley washer toward the bolt head, install the crankshaft pulley washer to the crankshaft bolt.
7.Tighten the crankshaft pulley bolt to the specified torque of 50 N·m.
8.Tighten the crankshaft pulley bolt 90° in the specified order.
9.Loosen the crankshaft pulley bolt fully.

10.Tighten the crankshaft pulley bolt to the specified torque of 50 N·m.
11.Tighten the crankshaft pulley bolt 90° in the specified order.