|
1.Remove the oil pan
mounting bolts.
2.Knock the special tool Oil pan
remover (MD998727) between the oil pan and cylinder
block as shown in the illustration.
3.Tapping the
side of the special tool Oil pan remover (MD998727), slide
the tool along
the oil pan/cylinder block seal and thus remove the oil
pan.
|
|
Install the oil jet in such a way
that its pin is located at the illustrated
position.
|
|
1.Apply sealant at the
bottom of the mating surface of lower crankcase and timing
gear case.
2.Apply even beads of sealant without
skips to the circumferential mating surface of
the oil pan as shown. Bead diameter 3.5 ± 1
mm
|
|
3.Install the oil pan to the
lower crankcase within 15 minutes after the application
of sealant.
Specified
sealant:
Mitsubishi Genuine Part No.4171 or
equivalent
| caution |
- The surface to be coated with sealant
must be clean and free of slush and
other foreign matters.
- When installing, take care that sealant
does not smear other places.
- After the oil pan is installed, wait for
at least one hour before starting the
engine.
- Remove and reinstall the oil pan with
fresh beads of sealant whenever the
bolts
(holding the oil pan) were loosened or
removed after the installation.
|
|
|
| caution |
If the gasket is installed in
the wrong direction, oil leaks will
occur.
|
Install the drain plug gasket in the direction
shown.
|
