|
1.Start the engine and allow
it to warm up until the temperature of the engine coolant
reaches 80 °C to 90 °C.
|
|
2.
warning |
Use care as engine oil could
be hot.
|
Remove the engine oil filler cap.
|
|
3.Remove the engine oil pan
drain plug to drain engine oil.
|
|
4.Remove the under
cover.
|
|
5.Use special tool oil
filter wrench (MB991610) to remove the engine oil
filter. 6.Clean the filter bracket side mounting
surface.
|
|
7.Apply a small amount of
engine oil to the O-ring of the new engine oil
filter. 8.Once the O-ring of the engine oil filter
is touching the flange, use the special tool (MB991610) to
tighten to the specified torque. Tightening
torque: Approximately 3/4 turn (14 ±
2 N·m) 9.Install the engine oil pan
drain plug and refill the engine oil (Refer to ). 10.Install
the engine oil filler cap. 11.Race the engine
2-3 times, and check to be sure that no engine oil
leaks from installation section of the engine oil
filter. 12.Install the under cover.
|