ENGINE OIL FILTER REPLACEMENT <4M4>


1.Start the engine and allow it to warm up until the temperature of the engine coolant reaches 80 °C to 90 °C.
2.
warning Use care as engine oil could be hot.
Remove the engine oil filler cap.
3.Remove the engine oil pan drain plug to drain engine oil.
4.Remove the under cover.

5.Use special tool oil filter wrench (MH061590) to remove the engine oil filter.
6.Clean the filter bracket side mounting surface.

7.Apply a small amount of engine oil to the O-ring of the new engine oil filter.
8.Once the O-ring of the engine oil filter is touching the flange, use the special tool (MH061590) to tighten to the specified torque.
Tightening torque:

    Approximately 5/8 turn (20 ± 2 N·m) <4M40>
    Approximately 3/4 turn (22 ± 2 N·m) <4M41>
9.Install the engine oil pan drain plug and refill the engine oil (Refer to ).
10.Install the engine oil filler cap.
11.Race the engine 2-3 times, and check to be sure that no engine oil leaks from installation section of the engine oil filter.
12.Install the under cover.