Inspection Procedure 2: The engine warning lamp does not illuminate right after the ignition switch is turned the ON position

COMMENTS ON TROUBLE SYMPTOM

• The combination meter illuminates engine warning lamp for 5 seconds just after the ignition switch is in ON position.
  
• If the engine warning lamp does not illuminate just after the ignition switch is in ON position, the causes of this failure may be the defective engine warning lamp or any open/short circuit in the combination meter, etc..
  

PROBABLE CAUSES

• Failed engine warning lamp
  
• Open/short circuit in the combination meter
  

	Inspection chart for diagnosis code (Refer to ).

	Go to Step 2 .

	Replace the combination meter assembly.

	Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).