Inspection Procedure 19: Overheating


COMMENTS ON TROUBLE SYMPTOM



PROBABLE CAUSES



DIAGNOSIS PROCEDURE

STEP 1. M.U.T.-III diagnosis code

Q. Is diagnosis code set?
Inspection chart for diagnosis code (Refer to ).
Go to Step 2 .

STEP 2. Check engine coolant.
note When the engine coolant level is too low, check for any section that cases leakage and repair, if necessary.

  • Check engine coolant (Refer to GROUP 14 - On-vehicle Service - Engine Coolant Leak Check ).

Q. Is the check result normal?
Go to Step 3 .
Replace or fill the engine coolant.

STEP 3. M.U.T.-III actuator test

  • Item 14: Cooling fan
OK: Fan motor rotates at high speed.

Q. Is the check result normal?
Go to Step 4 .
Check fan control relay system (Refer to GROUP 55 - Troubleshooting - Inspection Procedure for Trouble Symptoms - Condenser Fan Does Not Operate ).

STEP 4. M.U.T.-III data list

  • Item 06: Engine coolant temperature sensor
OK:
    Engine cold state: At ambient temperature (atmospheric temperature) or equivalent.
    Engine hot state: At 80 - 120°C

Q. Is the check result normal?
Go to Step 5 .
Check engine coolant temperature sensor system (Refer to Code No.P0117 : <Engine Coolant Temperature Sensor Circuit Low Input>, Code No. P0118 : <Engine Coolant Temperature Sensor Circuit High Input>).

STEP 5. Check thermostat.

  • Check thermostat (Refer to GROUP 14 - Thermostat - Inspection ).

Q. Is the check result normal?
Go to Step 6 .
Replace the thermostat.

STEP 6. Check water pump.

  • Check water pump.

Q. Is the check result normal?
Replace the radiator.
Replace the water pump.