|
- Temporarily place the ignition switch in LOCK (OFF) position, and 10
seconds
after that, place it in ON position again.
|
|
Q.
Is the diagnosis code of P1603 output?
|
|
- Disconnect connector and measure at harness side.
- Ignition switch: ON
- Voltage between terminal No. 58 and earth.
|
|
Q.
Is the check result normal?
|
|
Check intermediate
connector A-03 <L.
H. drive vehicles> or D-137 <R. H. drive vehicles> and repair
if necessary. If intermediate
connector is normal, check and repair harness between the battery and
D-244 (terminal No. 58)
engine-ECU <M/T> connector or D-214 (terminal No. 58)
engine-A/T-ECU <A/T> connector.
- Check power supply line for open/short circuit.
|
|
|
|
Q.
Is the check result normal?
|
|
Repair
or replace the connector.
|
|
|
|
- Check power supply line for damage.
|
|
Q.
Is the check result normal?
|
|
Repair
the damaged harness wire.
|
|
|
|
- Reconfirmation of diagnosis code.
|
|
Q.
Is diagnosis code set?
|
|
Replace the engine-ECU <M/T>
or engine-A/T-ECU <A/T>.
|
|
|
|
Intermittent malfunction (Refer to
GROUP 00 -
How to Use Troubleshooting/Inspection
Service Points -
How to Cope with Intermittent Malfunctions ).
|
|
|