2.Measure resistance between terminal No. 5 and No. 6 at the throttle valve control servo connector.
Standard value: 0.3 - 100 Ω (at 20 °C)
3.If resistance is outside the standard value, replace the throttle body assembly.
OPERATION CHECK |
| 1.Remove the air intake hose
from the throttle body. |
| 2.Turn the ignition switch
to "ON" position. |
| 3.Make sure that the
throttle valve is open. |
| 4.Turn the ignition switch
to "OFF" position. |
CHECK THE COIL RESISTANCE |
|
1.Disconnect the electronic
- controlled throttle valve connector. 2.Measure resistance between terminal No. 5 and No. 6 at the throttle valve control servo connector. Standard value: 0.3 - 100 Ω (at 20 °C) 3.If resistance is outside the standard value, replace the throttle body assembly. |