Code No. P1273: Supply Pump Insufficient Flow

OPERATION

Refer to Code No. P0335: Crank Angle Sensor System .
Refer to Code No. P0340: Camshaft Position Sensor System .
Refer to Code No. P0628: Suction Control Valve Open .
Refer to Code No. P0629: Suction Control Valve Battery Short .

FUNCTION

The engine-ECU controls the fuel discharge rate using the suction control valve.
The engine-ECU monitors changes in the fuel discharge rate at each injection to detect a fault in one of the two plungers in the supply pump.

TROUBLE JUDGMENT

Check Condition

Vehicle in steady and stable state (the difference from the last data of the objective common rail pressure is less than 3 MPa and that from the last data of the final fuel injection rate is less than 2 mm³/st.

Judgment Criterion

The inter-cylinder difference in pressure feed exceeds the predetermined value 100 times consecutively.

PROBABLE CAUSES

Air penetration due to lack of fuel
Failed supply pump
Failed engine-ECU

DIAGNOSIS PROCEDURE

note

This diagnosis code is outputted for an air penetration in the fuel line of the supply pump due to lack of fuel. Therefore, bleed air from the fuel line after the fuel supply, and delete the diagnosis code through M.U.T.-III.

STEP 1. M.U.T.-III diagnosis code

With the air released from the fuel line, supply fuel if necessary.
Continue idle operation for about 5 minutes.

Q. Is the diagnosis code P1273 outputted again?

	Go to Step 2.

	The check is end.

STEP 2. Replace the supply pump assembly.

After replacing the supply pump assembly, re-check the trouble symptoms

Q. Does trouble symptom persist?

	Replace the engine-ECU. When the engine-ECU is replaced, write the chassis number (Refer to GROUP 00 - How to Perform Chassis Number Writing ). After replacing the engine-ECU, register the injector identification code and learn fuel injection. (Refer to GROUP 00 - Precautions Before Service - What The Common Rail Engine Learns ).

	The check is end.