<SHORT WHEELBASE> |
1.Slide the front seat
(R.H.) forward and turn up the service hole notch on the
floor carpet. |
2.Remove the service hole
cover. |
<LONG WHEELBASE> |
1.Tumble the second seat
(R.H.). |
2.Remove the service hole
cover (upper side). 3.Remove the second seat (R.H.) (Refer to GROUP 52A - Second Seat ). 4.Remove the rear scuff plate (R.H.) and lower centre pillar trim (R.H.) (Refer to GROUP 52A - Trim ). 5.Remove the rear heater grille (R.H.) <Vehicles with Dual A/C> (Refer to GROUP 55 - Duct <Rear side> ). 6.Turn up the floor carpet. |
7.Remove the service hole
cover located between the front seat and the second
seat. |
8.Disconnect the fuel tank
gauge unit harness connector. 9.
10.
11.Connect the fuel tank pump gauge unit harness connector. 12.Install the service hole cover located between the front seat and the second seat. 13.Restore the floor carpet, and then install the rear heater grille (R.H.) <Vehicles with Dual A/C> (Refer to GROUP 55 - Duct <Rear side> ). 14.Install the lower centre pillar trim (R.H.) and rear scuff plate (R.H.) (Refer to GROUP 52A - Trim ). 15.Install the second seat (R.H.) (Refer to GROUP 52A - Second Seat ). 16.Install the service hole cover (upper side). 17.Restore the second seat (R.H.). |