REMOVAL AND INSTALLATION


Pre-removal Operation
  • Battery and Battery Tray Removal (Refer to GROUP 54A - Battery ).

 Post-installation Operation
  • Fuel Line Air Breeding (Refer to GROUP 13C - On-vehicle Service, Evacuation of Air from Fuel Line ).
  • Checking for Fuel Leaks
  • Battery and Battery Tray Installation (Refer to GROUP 54A - Battery ).




Removal steps


1.
 Fuel line heater connector <Vehicles for cold zone>


2.
 Water level sensor connector

>>B<<
 3.
 Fuel feed hose connection


4.
 Fuel filter assembly


5.
 Water level sensor
<<A>>
 >>A<<
 6.
 Fuel filter cartridge


7.
 Fuel filter pump


8.
 Air plug


9.
 Fuel filter bracket

REMOVAL SERVICE POINT

<<A>> FUEL FILTER CARTRIDGE REMOVAL

Fix the fuel filter pump to a vice, and then remove the fuel filter cartridge using an oil filter wrench.

INSTALLATION SERVICE POINTS

>>A<< FUEL FILTER CARTRIDGE INSTALLATION
1.Clean the mounting surface on the fuel filter pump side.
2.Tighten the fuel filter cartridge to the specified torque from the point where the gasket contacts the mounting surface.
Tightening torque: Approximately 3/4 turn (13.2 ± 1.5 N·m)

>>B<< FUEL FEED HOSE INSTALLATION

If the pipe has a stepped part, connect securely up to the stepped part. If the pipe has no stepped part, insert so that the inserted portion 20 - 25 mm long.