|
| caution |
Do not insert the screwdriver
tool deep as the stator core could be
damaged.
|
1.With a screwdriver blade inserted between
the front bracket and startor
core, pry to separate the stator ftrom the front
bracket.
2.If they are hard to separate, lightly
strike the bracket with a plastic hammer while
prying with the screwdriver.
|
|
| caution |
Use care not to damage the
rotor.
|
With the pulley side facing up, hold the rotor in a
vice and rimove the
pulley.
|
|
| caution |
- Use care that no undue force is exerted
to lads
of diodes.
- Check that the heat from the soldering
iron is not transmitted
to the diode for a long time.
|
1.Use a soldering iron (180 to 250 W) to
unsolder the stator.This work should complete
within approximately four seconds to prevent heat from
ransferring to the diode.
2.When removing the
restifier from the regulator assembly, unsolderd on the
rectifier.
|
|
Ater installing the regulator
assembly, insert a wire through the hole
provided on the rear bracket while pressing down on the
brush, and secure the brush.
| note |
By inserting a wire, the brush
will be secures in place, and the installation
of the rotor
will be easier.
|
|
|
After installing the rotor, remove
the wire used to secure the brush.
|
