|
1.Turn A/C and lamps
OFF. Inspect and adjust at no load.
|
|
2.Warm engine until
stabilized at idle.
|
|
3.Confirm idle speed is at
standard value. Standard value: 750 ± 100
r/min
|
|
4.Stop engine
[ignition switch: "LOCK" (OFF)
position].
|
|
5.Confirm there are no sharp
bends in the accelerator cable.
|
|
6.Check the inner cable for
correct slack. Standard value: 1.0 - 2.0
mm
|
![](../../../img/17/AC610565AB00ENG.png)
|
7.If there is too much slack
or no slack, adjust play by the following procedures. (1)
Loosen the lock nut and fully close the throttle
link. (2)
Tighten the adjusting nut until immediately before the
throttle link starts to move. (3)
by loosening the adjusting nut one turn, the accelerator
cable play will be brought
to the standard value. (4)
Fix the adjusting nut with the lock nut.
|