REMOVAL AND INSTALLATION

Pre-removal Operation

Ornament Driver Side Panel Removal (Refer to GROUP 52A - Instrument Panel Assembly ).

Post-installation Operation

Ornament Driver Side Panel Installation (Refer to GROUP 52A - Instrument Panel Assembly ).
Accelerator cable adjustment (Refer to ).

<L.H. drive vehicles>

		Accelerator cable removal steps
	1.	Inner cable connection (Fuel injection pump side)
	2.	Inner cable connection (Accelerator pedal side)
	3.	Accelerator cable
		Accelerator pedal removal steps
	2.	Inner cable connection (Accelerator pedal side)
	4.	Accelerator pedal assembly
	5.	Push-on spring nut
	6.	Accelerator pedal arm and accelerator pedal pad assembly
	7.	Bushing
	8.	Spring
	9.	Stopper
	10.	Accelerator pedal bracket
	11.	Accelerator pedal arm
>>B<<	12.	Accelerator pedal pad
>>A<<	13.	Accelerator pedal stopper

<R.H. drive vehicles>

		Accelerator cable removal steps
	1.	Inner cable connection (Fuel injection pump side)
	2.	Inner cable connection (Accelerator pedal side)
	3.	Accelerator cable
		Accelerator pedal removal steps
	2.	Inner cable connection (Accelerator pedal side)
	4.	Accelerator pedal assembly
	5.	Push-on spring nut
	6.	Accelerator pedal arm and accelerator pedal pad assembly
	7.	Bushing
	8.	Spring
	9.	Stopper
	10.	Accelerator pedal bracket
	11.	Accelerator pedal arm
>>B<<	12.	Accelerator pedal pad
>>A<<	13.	Accelerator pedal stopper

INSTALLATION SERVICE POINTS

>>A<< ACCELERATOR PEDAL STOPPER INSTALLATION

1.Insert the accelerator pedal stopper straight into the stud bolt of the floor.
2.After the installation, slightly pull the accelerator pedal stopper by hand to check that it cannot be removed easily (appropriate holding power: 100N or more).

>>B<< ACCELERATOR PEDAL PAD INSTALLATION

caution

To prevent damages to the accelerator pedal pad, warm the thumb area of the accelerator pedal pad with a dryer, etc. prior to assembling it.

note

If it is difficult to assemble, apply soapy water to the thumb area to enhance the assembling process.