REMOVAL AND INSTALLATION

caution

Never loosen the screw fixing the accelerator pedal assembly resin cover. If the screw is loosened, the sensor position which exists inside the resin cover is off and the accelerator pedal position sensor does not work normally.
Do not remove the accelerator pedal pad. If the pad is removed and installed, excessive force may damage accelerator pedal position sensor.

Pre-removal and Post-installation Operation

Ornament Driver Side Panel Removal and Installation (Refer to GROUP 52A - Instrument Panel Assembly ).

		Removal steps
	1.	Accelerator pedal position sensor connector
	2.	Accelerator pedal assembly
>>A<<	3.	Accelerator pedal stopper

INSTALLATION SERVICE POINT

>>A<< ACCELERATOR PEDAL STOPPER INSTALLATION

1.Insert the accelerator pedal stopper straight into the stud bolt of the floor.
2.After the installation, slightly pull the accelerator pedal stopper by hand to check that it cannot be removed easily (appropriate holding power: 100N or more).