DISASSEMBLY AND REASSEMBLY

			Disassembly steps
<<A>>	>>A<<	1.	Ball bearing
	>>B<<	2.	Snap ring
<<B>>	>>A<<	3.	Spacer
<<B>>	>>A<<	4.	Roller bearing
<<B>>	>>A<<	5.	Inner race
		6.	Counter shaft gear

DISASSEMBLY SERVICE POINTS

<<A>> BALL BEARING REMOVAL

Use special tool Remover (MD998801) to remove the ball bearing.

<<B>> SPACER, ROLLER BEARING AND INNER RACE REMOVAL

1.Remove the spacer and bearing.

2.Using special tool, remove the inner race.

Remover (MD998801)
Bearing installer (MD998368)

note

The removal sequence of roller bearing parts vary depending on the direction that the roller bearing was installed, In come cases, the inner race, roller bearing and spacer may have to be simultaneously removed.

REASSEMBLY SERVICE POINTS

>>A<< INNER RACE, ROLLER BEARING AND SPACER INSTALLATION

1.Use special tools to install the inner race.

Installer cap (MD998812)
Installer adapter (38) (MD998818)

2.Install the roller bearing and spacer.

>>B<< SNAP RING INSTALLATION

1.Install the thickest snap ring that can be fitted into the snap ring groove of the counter shaft gear.
2.Make sure that the counter shaft gear roller bearing end play meets the standard value.
Standard value: 0 - 0.08 mm

>>C<< BALL BEARING INSTALLATION

Use special tools to install the ball bearing.

Installer cap (MD998812)
Installer adapter (38) (MD998818)