|
1.Drain the A/T fluid.
note |
The hydraulic pressure test
must be performed before attempting any
adjustments.
|
|
|
2.Remove the valve body
cover.
|
![](../../../img/23/AC100548AC00ENG.png)
|
3.Turn the adjusting screw
shown in the illustration to adjust the line pressure to the
standard value. The pressure increases when the screw is
turned anti-clockwise.
note |
When adjusting the line
pressure, adjust to the middle of the standard
value range.
|
Standard value: 1.01 - 1.05 MPa
(Change in pressure for a single full of the adjusting
screw: 0.035 MPa) 4.Install the valve body
cover, and then pour in the specified amount of A/T
fluid. 5.Repeat the hydraulic pressure test (Refer
to ). Readjust
the line pressure if necessary.
|