Key interlock
side
|
Inspection
procedure
|
Inspection
requirements
|
Inspection item
(normal condition)
|
1
|
Brake pedal:
Depressed
|
Ignition key
position: LOCK (OFF) or removed
|
Unable to push in
the selector lever push button and move the lever out of the
P position.
|
2
|
Ignition key
position: ACC
|
Able to push in the
selector lever push button, move the lever out of the P
position, and shift to any position.
|
3
|
Brake pedal: Not
depressed
|
Selector lever:
Other than P position
|
Unable to turn the
ignition key to the LOCK (OFF) position.
|
4
|
Selector lever: P
position
|
Able to turn the
ignition key to the LOCK (OFF) position.
|
|
1.When any of the above
checks are not normal, adjust the shift lock cable unit in
following procedure.
(1)
Remove the front floor console (Refer to GROUP 52A -
Floor Console Assembly  ).
(2)
Shift selector lever to P position.
(3)
Turn the ignition key to LOCK (OFF) position.
(4)
Loosen the bolt fixing the shift lock cable unit, push the
lever in direction B and the unit in direction C and tighten
the bolt at the standard torque.
Tightening
torque: 5.0 ± 1.0 N·m
(5)
Lift the lock guide of the key interlocking cable and then
unlock it.
(6)
Lower the lock guide of the key interlocking cable and then
lock it.
|
|
| note |
The key
interlocking cable is adjusted
according to the lock position (cap
push state) at this time. Readjust
the lock position if key
interlocking operations malfunction
after locking.
|
|
2.After adjustment, re-check the operations.
Replace the shift lock cable unit if operations are
defective (Refer to ).
|